Joined: May 24, 2009
Posts: 31
Go to the Start menu
Open your CMD promt
Once in the CMD
type the following
ipconfig /release all
ipconfig /flushdns
ipconifg /renew all
This will flush any bad DNs cache on the local machine. Also you may have a good amount of Maleware.
What stuff are you using to counteract these?
Joined: Feb 07, 2009
Posts: 178
Location: Out There, USA
With ipconfig /release all I get "The operation failed as no adapter is in the state permissible for this operation" Should this be done in my router?
As far as Malware I don't have a problem with it. My firewall is on, I use CCleaner about two times a week, SpyBot every other day (before gaming) and Virus scan once a week. Any suggestions for Malware protection? Especially free.
Joined: May 24, 2009
Posts: 31
OK also i will say you need one more items .
Malewarebytes.org ..
Also free please get that.
As for the Operation failed Few things you have XP. ?
Joined: May 24, 2009
Posts: 31
Also Dont forget to do this operation at the end in the CMD prompt
/ipconfig /registerdns
Impsrtant
Joined: Jun 23, 2009
Posts: 52
Location: Victoria, BC, Canada
Weird, I can't see an initial post with the details on this. Sounds like your TCP stack is corrupted. Try the following...
In a command prompt type netsh winsock reset catalog and enter
Then type netsh int ip reset reset.txt and enter
Reboot
This will reset your network stack fixing your winsock issues. If there's anything else wrong, cross that bridge after this fix.
Note: If you have a software firewall or other 3rd party (non-Windows) protection software and experience problems after this, re-installing the applications from scratch is advisable.
Joined: Jun 23, 2009
Posts: 52
Location: Victoria, BC, Canada
Rc7....hmmmm
I just recalled that I had a similar error when I installed vista64 on a machine I built for a co-worker awhile back. After much hairpulling (figuratively speaking, I'm bald
) I managed to resolve this.
Since i can't see an initial post describing the problem, could you answer a couple questions for me? If you run ipconfig in cmd prompt, what IP address do you get? Also, what make and model of router do you have?
EDIT - Er...I hope you don't mind me barging in to offer help. I can't help but wonder what problem prompted this thread. I saw you have this error message "The operation failed as no adapter is in the state permissible for this operation" on address renewal attempt. Normally this would be associated with an inability to get online, but I see Bullitt playing on the server now so either it's fixed or I'm missing something here, lol.
Joined: May 24, 2009
Posts: 31
No this is to just clean The ip/dns .. Didnt think to use the Netsh
But i doubt its the issue . But use it .
Joined: Feb 07, 2009
Posts: 178
Location: Out There, USA
My router issued .146 for my IP. Even after the errors it all works and my connection speed is slightly better but my pings to the server are much lower. Average 40-50 on server one. I was in the 70"s. Not sure if it makes a difference. I have a Linksys WRT54G with a DD-WRT V24sp1 bios flash. By the way my version of Win7RC1 is 64bit. Forgot to mention that.
